Board logo

ZX9 R
Shogun969 - 2/12/06 at 09:35 PM

Hi,
Can anyone with Knowledge of the ZX9 B engine confirm the size of the resistor required to be fitted in the ECU Ign feed Please ?

I have installed a 100 ohm resistor, i have a spark and petrol but it back fires every now and again when being turned over and wont actually fire up and run .

Any suggestions ?
Thanks

Wadders - 2/12/06 at 09:58 PM

100ohms is correct, are you sure the plug leads are on the right plugs?






Originally posted by Shogun969
Hi,
Can anyone with Knowledge of the ZX9 B engine confirm the size of the resistor required to be fitted in the ECU Ign feed Please ?

I have installed a 100 ohm resistor, i have a spark and petrol but it back fires every now and again when being turned over and wont actually fire up and run .

Any suggestions ?
Thanks

Shogun969 - 2/12/06 at 10:03 PM

Hi,
I believe plug leads are right 1 coil to plugs 1 & 4 , the other to 2 & 3, i have checked this against the wiring diagram but will recheck it tommorow.
Thanks

JoelP - 2/12/06 at 10:44 PM

on my C engine, the leads were paired 1+2 and 3+4, but thats not saying much since i cant count and dont have the engine anymore anyway.

mac1 - 2/12/06 at 11:50 PM

Hi Nick, you have U2U


Mark