linky
ETDWM!
Works off two microswitches (one for up, one for down), adjusting them takes a while but once that's sorted it works well.
If we're talking gear change indicator, there are quite a few shift light circuits out there....
What would be the best gear change indicator for the Fireblade and where can I get one. Davy
Ive got one of the digi gear indicators, well worth the buy, sometimes on sale on ebay.
http://www.acumen-electronics.co.uk/shop/products.php?category=3
Assuming you are talking about gear position indicators rather than shift lights, then as welderman says, the acumen unit is a good unit, simple to
fit and works well.
We fitted one last week to our Indyblade, paid about £50 on e-bay.
Simon
[Edited on 2/1/07 by asn163]
If we're talking gear indicator there is a DIY option available
linky
ETDWM!
Works off two microswitches (one for up, one for down), adjusting them takes a while but once that's sorted it works well.
If we're talking gear change indicator, there are quite a few shift light circuits out there....