To those who are using the original bike m/c for the clutch - How are you mounting the m/c and how are you actuating it from the pedal? I have a few ideas of my own but would like to see if there is a concensus or an option that stands out.
Thanks in advance.
Richard

I’m going to use a bike rear brake cylinder as it is easier to mount!

yupsz this is generly done....

to operate the clutch only piston diameter is nececary, stroke is important but not deadly...

Tks

I weld a bracket at right angles to the frontplate of the pedal box with 2 holes to bolt into the original m/cyl mounts, cut off the end of the ali casting on the clutch m/cyl (in my case old ZX10) as it's not required & grind down the end of the car operating pushrod (in my case MR2) to the size of the bike pushrod - 4mm dia IIRC. Does the job a treat & looks neat when finished. HTH

Just added the pics to my photo archive if you want to see how I did it. HTH