With the camber adjusters pressed home, there is no way of getting a 25mm socket in to turn them, any ideas. The edge of the 2 wishbone tubes are to close to the tube where the end of the adjuster presses home..
Rescued attachment 15102008038.jpg

I have a similar set up on my MotaLeira eccept the heads on my adjusters are round. They have holes drilled through at right angles so that I can use a rod to turn them and also the holes can be used to lockwire them.
You could cross drill the bolt cap.



rod adjuster

[Edited on 3/12/2008 by nitram38]

It shouldnt be a problem, mine is same set up, to adjust i just loosen the outboard locknut, rotate the adjuster by hand , and tighten the locknut. Just make sure the adjuster turns freely

Make some like these.

Phil

[img][/img]

They were tight when they went in, i had cleaned them wishbones out with a dremal and cleaned the adjusters and copper slipped,

Sorted, cleaned out the wishbines even more with a dremal/sanding drum, spun the adjusters up in a lathe with some wet/dry and they now slide/turn, holes drilled to turn them

Wahoo......MotaLeira stylee...

Yep i thought it was a good idea, thanks