Can you have dual 0.70 mastercylinders on a bias bar system and still maintain the correct ratio? I have sierra front disks and rear drums...

Cheers

i'm pretty sure you can't, i tried the same thing and ran out of adjustment on the bias bar. But i can't remember what i used in the end,

I'm sure someone will come along and say you can now thou

I used the Sierra m/c (with servo removed), it works a treat and was free.

Can't help with you specific point though.

ATB

Simon

No, that would end up with the back end locking up too easy before the front.

If I was doing it again I wouldn't bother with a bias set up, IVA doesn't allow it these days and would just go for dual m/c, either the donor one or a new one.

[Edited on 6/12/09 by coozer]

Just to remove some confusion: IVA does allow bias bars as long as theyre welded once adjusted.

Dax have IVAed cars with this setup.

Sorted, got a 0.625 at last minute from Raceparts yesterday... long drive... but once properly bled it should be great.