Board logo

rover v8 to type 9 bell housing
Chris_Xtreme - 6/4/14 at 07:55 PM

i bought this a couple of years ago for over 100quid, didn' quite see the state of it on ebay, but went for it anyway as I was doing a sizing exercise to see if i could fit a rv8 and type 9 into the xtreme without chopping the chassis... (it didn't fit!) I sold that xtreme and have the v8 one so this is now surplus to me.

the seller told me it was in an escort and thus the cut down the side and also there is a siliconed on plate underneath no doubt to get up and attach the clutch arm...

I can confirm that it did bolt to the v8 and to the type 9, so it is what it says !


I'm thinking 40quid posted?












Chris_Xtreme - 8/4/14 at 09:59 PM

on ebay now starting 25quid.

http://r.ebay.com/MZQPSm