Here are some of the items I want to be rid of. I am amazed at how much stuff I have accumulated so I am having a good clear-out.

Please fell free to make offers

They are near Folkestone in Kent [CT187AX] but I am happy to post at your cost.

I can send pictures if you let me have an email address (I will slowly be trying to upload to my archive)

Two rear cross members for a Type 9 gearbox - both are in good used condition and come with the rubber mount and the mounting bolt + bell shaped washer.

Brake master cylinder and reservoir from a Mk V 1.8 TD Escort - I have taken it apart so that it can be inspected - used but good condition

Power steering reservoir (metal) + cap from Toyota (Supra?) - used

A pair of Sierra Track rod Ends (new)

A pair of Sierra track rod ends (used but good)

V6 Ford Cologne (& Pinto?) mechanical fuel pump & gasket - used

Sierra rear wheel bearings - 2 sets (new)

Starter motor - 1.8TD Mk V Escort - used but good

Starter motor - Lucas 5M90 - recon unit - fits ford V6 ( & Pinto?)

Starter motor - Lucas 2M100 - used but good - Ford V6

Front (Gearbox) end from Ford propshaft - I believe fits Type 9 4-speed (shaft is 30mm OD and 18 splines)

Front (Gearbox) end from Ford propshaft - I believe fits Type 9 5-speed (shaft is35mm OD and 25 splines)

Sierra sunroof trim surround and handle & handle surround panel

Ford servo (poss transit?) - new - m/c mounting bolts are approx 64 mm apart

Sierra Mk I plastic header tanks - one has screw cap and one has metal rad cap fitment (no cap with this one) - both used but good and clean

Fiesta Mk II header tank

Escort V header tank (screw cap)

Sierra plastic fuel filler pipe complete with ford cap & key

Ford V6Ford V6 (Cologne)

clutch pressure plate - n/o/s

engine front timing cover

Flex plate (for auto engine)

V6 Bosch electronic distributor

Radiators

Granada Mk II 2.8 radiator - effectively new - was trial fitted but never run on the road
Escort V radiator - used - quite a few bent fins but watertight
Sierra 4x4 radiator - used

Ford horn

V-belt pulley on adjuster arm (80mm diameter)

RV8 ally elbows for air intake system

RV8 air box (SD1 etc)

Steel engine mount arms (pair) - Pinto

Sierra wiper motor x 2 - used but gwo

Sierra wiper motor and cut-down linkage (adapted for Robin Hood but should fit other LSIS cars) - gwo

Pair of wiper arms - adjustable length >12"

Rubber handbrake gaiter x 2 - one for Cortina IV/V & one for Granada II

Rear view mirror (Sierra)

rubber gear stick gaiter


Ford washer pump motor and rubber pipe - used

Fuel Vapour Separator pot x 2 - Sierra - one has fuel hose attached and one has been painted - both used

Radiator temp thermostatic switch - threaded to fit Ford (and most other) radiators - On at 103 and off at 93 degrees - new

Ford Universal Joint Repair kit (90 AG 4635AA) - n/o/s

Type 9 gear stick - knob is marked for 4-speed but it will fit a 5-speed 'box as well

V6 Oil Filter x 2 - Delco filters bought for V6 cologne but I believe they will fit Pinto engines as well - new

Sierra plastic steering column bush kits - 3 new & one used but good

Type 9 Reverse switch inc wiring & plug

Ford Cortina V6 2.3 ignition amp & module

Used pair of underslung exhausts for a Pilgrim Sumo (Cobra replica) inc down-pipes for V6 Cologne engine - 48mm OD mild steel pipes with two narrow silencers on each side. [passed SVA noise test with these]

Used pair of underslung exhausts for Dax 427 Cobra replica - 2" OD mild steel pipes with one silencer on each side

4 silencer boxes - n/o/s - originated from Ford - still have labels on some

Sierra rear driveshaft repair kits - some metal cups have 73mm OD [83BX4K258AB] and some are 77mm approx [83BX258BB] - n/o/s/in ford boxes

Sierra oil seals x2 (approx 65mmOD [85AB1190AA] - n/o/s

Sierra oil seals x2 (approx 72mm OD [85GB1175AA] - n/o/s

Sierra caliper seal [81AB2B107AA] - n/o/s

Sierra accelerator pedal - used

Quote - Front (Gearbox) end from Ford propshaft - I believe fits Type 9 5-speed (shaft is35mm OD and 25 splines)

Am very interested in this item, 1st dibs pls. Will check my T9 box to verify output shaft dims.

Here are a couple of pics (can't seem to upload to my archive)

[img][/img]


[img][/img]

hi,

how much for a type nine gear box rubber and dished washer?

quote:

---

Originally posted by teegray19
hi,

how much for a type nine gear box rubber and dished washer?

---

U2u sent ref gear stick

FAO TG -

[img][/img]

Is the "Starter motor - Lucas 5M90 - recon unit - fits ford V6 ( & Pinto?) " still available, and if so how much are you looking for?

Hi Dave

Yes the starter is still available
[img][/img]


[img][/img]


[img][/img]


I bought a recon unit as a spare for my Cologne engine in my Robin Hood. Car has now gone so it's surplus to requirements.

How about £15 + postage?

Let me know if you have any questions

Robin

Can I get a price for the type 9 reverse switch and wiring and also the mechanical pinto fuel pump?

Hi, interested in the new Sierra Track Rod Ends .
How much and how much for postage ?

Cheers

quote:

---

Originally posted by Ashman86
Can I get a price for the type 9 reverse switch and wiring and also the mechanical pinto fuel pump?

---

quote:

---

Originally posted by alland3851
Hi, interested in the new Sierra Track Rod Ends .
How much and how much for postage ? Cheers

---

"Type 9 gear stick - knob is marked for 4-speed but it will fit a 5-speed 'box as well "

Is this still available, can you confirm it is a type 9 but with an odd knob on top, if so how much delivered ?

Thanks

quote:

---

Originally posted by Ugg10
"Type 9 gear stick - knob is marked for 4-speed but it will fit a 5-speed 'box as well "

Is this still available, can you confirm it is a type 9 but with an odd knob on top, if so how much delivered ?

Thanks

---

Type 9 Reverse switch inc wiring & plug

I'll take this if it's still available......
Cheers,
IanM

quote:

---

Originally posted by ianm67
Type 9 Reverse switch inc wiring & plug

I'll take this if it's still available......
Cheers,
IanM

---