Board logo

Griffin inlet plenum swap
Sierra - 22/8/14 at 03:57 PM

But of a long shot but thought I'd try anyway.
I've currently got a griffin plenum and would like to swap for a spencer ashley type plenum. Only reason is I need one that's angled upwards for clearance on the supercharger.

big_wasa - 22/8/14 at 08:43 PM

If I had one I would bite your hand of as they are NASTY.

pepper performance / Spencer Ashley = same thing.






Sierra - 22/8/14 at 08:49 PM

I've heard that they have changed and just awaiting pictures from them so shall see.

mark chandler - 22/8/14 at 09:27 PM

Cannot you get someone to modify what you have, it sounds like you just need a bit of metal added or a wedge cut out to change the angle so saves messing around with injectors, loom, fuel rail etc?

big_wasa - 22/8/14 at 09:51 PM

Ok I would love to see them.

Sierra - 22/8/14 at 09:56 PM

quote:
Originally posted by mark chandler
Cannot you get someone to modify what you have, it sounds like you just need a bit of metal added or a wedge cut out to change the angle so saves messing around with injectors, loom, fuel rail etc?


I did look into it but the only way would be to cut it at the flange and angle the 4 ports about 25 degrees, the problem would then be that the injectors would be at a strange angle and may mess things up.

mark chandler - 23/8/14 at 08:02 AM

My injectors are running upside down without any problem, with 3-4 bar of pressure behind them they do not care.

Get a 90 degree mandrel bend, chop it into 4 even parts and weld in