If anyone has a short piston for a 1600 X-flow (ideally a knackered one, 'cos it will be cheaper ) surplus to their requirements, I would
appreciate it.
Happy to part with beer tokens in the quest for knowledge.
Or where I might lay my sticky little fingers on one.
Any help appreciated.
[Edited on 18/5/09 by Confused but excited.]
What on Earth is a "short piston"?
All x-flow pistons are the same length, and have a compression height of 44.75mm, with only the size of the bowl changing...UNLESS it's an
aftermarket forged piston from Cosworth (or similar) with a compression height of either 39mm, ot 37.2mm to suit a longer steel conrod.
Dat's da bunny.
Thanks for the info, it's the 37.5mm that I wanted to know.
Cheers dude.
I knew someone would be able to help.
Ain't this forum great?