i'm after a rectifier for a 97 919 blade engine
cheers
steve
try
www.wemoto.com
About £80 far cheaper than a honda dealer!!
i got mine off ebay brand new for £50.
can also try a superdream, which has decent heat sink
Any 3phase bike regulator will do, on my bike I have a firestorm regulator after honda's finest failed, on my BEC a ducati one.
Just surf Ebay for regulators and get the biggest one with a heat sink you see for £5.
Regards Mark
^^^ wot they say. I recently fitted a GPz 500 regulator to replace rectifier/regulator on Z1000.
they come in 5 and 6 wire flavours.
3 wires for AC
1 0 V
1 for battery
and 1 regulated output (optional) for instruments.
quote:
Originally posted by bigsteve
i'm after a rectifier for a 97 919 blade engine
cheers
steve
I have a superdream one but be carefull as the wires were too small to take the load and get read hot, i even soldered them on to reduce any resistance the connector introduced.
quote:
Originally posted by mark chandler
Any 3phase bike regulator will do, on my bike I have a firestorm regulator after honda's finest failed, on my BEC a ducati one.
Just surf Ebay for regulators and get the biggest one with a heat sink you see for £5.
Regards Mark
thanks for the replies. i've spent hours surfing ebay and tbh i aint sure which one to get. could someone point me in the right direction please.
i'm not being lazy its just i dont want to get the wrong one or pay the earth for it
thanks again
steve
this one anygood??
http://cgi.ebay.co.uk/TRIUMPH-REGULATOR-3-PHASE-12v-T140E-D-TSS-TSX-NEW_W0QQitemZ220501356379QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item33
56e7af5b
Genuine/Original honda superdream 250/400n, Use only an original one not a pattern/replacement
I burnt 4 blade ones out before I fitted the superdream one, should cost between £25 and £40 on ebay, they used to be cheap untill people caught on
they were a replacement for the blade
theres a wiring diagram on here somewhere
tony
[Edited on 5/11/09 by mad-butcher]
This looks second hand but it's the type you are looking for.