I have managed to fook the end of my welder, is a migmate 130. So basically I need the big brass thing that sits inside the torch (you'd know what I mean if you got one). By any chance would anyone have an unusable sip welder with a half decent torch, or am I best going to SIP for a replacement part?

Am trying to trawl ebay for a non-functioning welder, but will cost me a fortune in postage.

cheers
Mark

and yes I realise this should probably have been in the wanted section. ah well

[Edited on 31/8/04 by 9904169]

You have a u2u, will look fer a reply tomorrow
Shug.

You killed the gas valve???

What on earth were you doing?

Give sip parts a call, Doubt it will be more than £10-£15

TT

quote:

---

Originally posted by 9904169
I have managed to fook the end of my welder, is a migmate 130. So basically I need the big brass thing that sits inside the torch (you'd know what I mean if you got one). By any chance would anyone have an unusable sip welder with a half decent torch, or am I best going to SIP for a replacement part?



Am trying to trawl ebay for a non-functioning welder, but will cost me a fortune in postage.

cheers
Mark

and yes I realise this should probably have been in the wanted section. ah well

[Edited on 31/8/04 by 9904169]

---

hope this helps

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=1268&item=3835274844&rd=1


or

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=64818&item=3836636881&rd=1

Doubt it,

If so then they are available at FruadHalfs of the shelf..

But a big brass bit sounds like the gas valve unit.. Amout 1" by 1/2" by 1/2" brass block..

TT

have a little drawing of the bit i need. I realise now why my grades in art were so poor!

cheers
Mark

That shows the gas valve and swan neck.

try sip...

http://www.sip-group.com/

Speak to this guy

http://www.welduk.com/

He'll help you. He helped me convert my SIP 150 to a EURO torch setup.

Knows what he's talking about.