Does anyone have a drawing for a Toyota 4AGE intake manifold gasket, described as valve gasket in the picture below, as i need one to send to the
lazer cutters and i don't have a scanner.
If anyone can help that would be great, also could you put a scale alongside if you have one.
Many thanks Dan.
[img][/img]
I have a spare gasket that is not required would this help you out.
Just make sure you send them the correct one. Don't know if you need wide port or narrow port?
Ben
I've a early wide port head. The old gasket is about some where but i was hoping just to do the deal over the internet.
Dan.
I do not require any cash will post it at work for free just send your address and I will send it.
Rusty U2U sent
Dan
I can let you have a drawing but my CAD man is away for the next week.
Rich
Did anyone ever come up with a drawing for this? I am particularly interested in the positions of the mounting holes on the flange. Not bothered if
TVIS or not, as the mounting holes are the same.
I am getting a flange cut on a water jet and need to give him a CAD drawing. I have measured and drawn up the ports, but the mounting holes are
randomly spaced and positioned. So if anyone has something i would be delighted to hear from them.
Thanks