Anyone a dab-hand welding thin piping?

Would like the majority of the bend cutting out of these water connectors.

Beer vouchers available



Original water connectors

Cheers,

If you're stuck and can't get them done locally I'll do them. It's about 50 miles from here to Leicester. Cut a 'V' out to get them to the angle you want. You could cut the bend out and join them with coolant hose and clips.

I know a bloke round the corner from me who will do that for you drop me a U2U (I am in Mountsorrel near Loughborough)

My mate in Enderby will do that for you, send me a u2u and I will give you his phone number.

Cheers guys,

An alternative "might" have just occured.

If that doesn't come to anything, I'll get back to you kind gents

[Edited on 13/11/06 by skidude88]

I can do it and I am in barwell if thats any use

Hi

See photo below... If your engine were a R1 it would be a perfect fit!!!

As you can see there are a few differences, one being the take off nipple..

Might be best just doing a cut and shut job.. Now if I had my new TIG!!..

[Edited on 15/11/06 by athoirs]
Rescued attachment P1010238.JPG

Cheers for the pic,

Was worth a try, like you say prob go for cut'n'shut.