Yup... Sierra Rear Hub Nuts can be a real pain to undo... But with this, and a 9ft pole, it came undone with ease. Mind you the Socket set bar complained a bit



Are your Nuts Too Tight?

GGGrrrrrrr LOAD... You Damn Picture... Grrrrr

Tight Nut Undoer






[Edited on 5/12/2004 by wilkingj]

[Edited on 5/12/04 by ChrisW]

where there's a will there's a way....

Yeah, mine were real bas***ds! Problem was, i didnt know about the left hand thread and ripped the poo outta it. Fixed now tho

Carefully inspect that tiny bit of thread protruding from the nut, you can see which hand it is, and act acordingly.

Also make sure you put them on the right sides, when you build the car, as they could Both come undone if you dont!.

When i was refiting my sierra rears i was told to remember that i should allways tighten towards the front of the car,so near side is left hand thread.

Yup... Sierra Rear Hub Nuts can be a real pain to undo... But with this, and a 9ft pole, it came undone with ease. Mind you the Socket set bar complained a bit


[img]/upload/2DSCF0073.JPG[/img]

GGGrrrrrrr LOAD... You Damn Picture... Grrrrr

You might have problems with brake balance!!!

Nope... but it vibrates a bit... Ho Hummm

I like that........the pole and the brake balance

Ever thought of using explosives !

just a thought !

yeah,, same prob over here


also didn't now about the left hand thread..


i now have still almoste the complete nut in thread over..

i'm thinkg about buying a new one ore just fill the room up with somepiece of tube or so..

TKS

"You don't born with fear, you are shaped to!"