im just wundering how to fit these as they curve and dont fit the chasis. anyone got an idea.
Rescued attachment rear wing.JPG

I take it u dont have any excess at the outside edge that would allow u to trim the curve off to make em fit.
Shug.

Probaly best to sell the Dax wings and buy a pair from Luego. Two different widths p/n K1=215mm i/d (Escort size axle) £72/pair and p/n K2=280mm i/d (Cortina size axle) £83/pair

Are they a set of seconds or are all Dax rear wings like that?

It would be an easy job to cut out the offending area and graft in a replacement flange.

I used Dax rear wings, had the same gap in the same place. by the time its bolted on with the wing piping in place its not noticeable
Hope this helps