Hi everyone I'm looking for a couple of strips of plastic or alloy to raise my nose cone and my bonnet from the chassis as the bonnet is touching my cambelt ,I'm looking for about 2x 1.5 metres long and about 30 mm width and 15-18 mm thick I've tried every ware from BBQ ,wicks and even a plastics place but no joy

Aluminium box section, I used some to raise my boot lid, from eBay.

Have a look on ebay

Can you not lower your engine

As above use box section alli. It's really light and strong. You could cover in carbon on spray same colour as your body. Are you raising the scuttle as well ? Otherwise the bonnet won't fit to it.

Or use a bonnet bulge or scoop save a lot of messing about? Plus the come in carbon so you don't need to paint etc.



[Edited on 20/8/14 by jossey]

The early KIA Sedona bonnet scoops are removable, and fit a Seven bonnet without much hassle Genuine Kia Sedona Complete Bonnet Grey CRDI 2.9 LE SE LX 1998 - 2006

Hi all I've already got a bonnet scoop but it's too far back and I can't really lower the engine any lower as it scrapes getting it of my driveway , I've tryed looking on ebay for box section but all I can find is actual square box but I need it wider than higher

ClickMetal do 11/2"x 3/4", but the postage kills it ClickMetal

I used ali channel with the open side towards the chassis rail. Got it from B&Q or wickes its normally kept with their steel box/angle iron and other ally sections you have to go in store though they dont show it online.But as normal with B&Q and its a bit of a rip off for what you get.
Cheers,
Bob

oh i replied on the other thread you made...