Board logo

Cleaning Duct tape off bodywork
the_fbi - 4/2/06 at 10:24 AM

Whats the best liquid for removing duct tape residue from pieces of bodywork?

Clearly I don't want to eat away or get nasty white smears all over it.

Its just the white sticky-ness which is left I think due to being taken off when it was so cold


Hellfire - 4/2/06 at 10:26 AM

Try some white spirit on a cloth.


indykid - 4/2/06 at 10:29 AM

brake cleaner works well too.

it smells nicer and doesn't leave the residue that white spirit does either.

tom


02GF74 - 4/2/06 at 10:39 AM

paraffin, petrol white spirit will shift it.

brake fluid, hmmmm, doesn't it say do not pour onto paint? ... but should be ok if you wipe it off immediately.


Avoneer - 4/2/06 at 10:45 AM

If it's on your GRP - use some Farecla G3 - that'll clean it off easily.

Pat...


donut - 4/2/06 at 10:50 AM

02GF74: He said Brake cleaner not brake fluid......now that woul dbe silly!


britishtrident - 4/2/06 at 10:53 AM

T Cut


JohnN - 4/2/06 at 11:42 AM

Brillo pad, like my wife used on bird poo on her Jeep once, cos she had heard that you shouldn't leave it else it'll damage the paint


the_fbi - 4/2/06 at 11:46 AM

quote:
Originally posted by Avoneer
If it's on your GRP - use some Farecla G3 - that'll clean it off easily.

Pat...

Interesting one, but I think there is too much sticky left for G3 to shift it. It needs a solvent first.

I'll give some white spirit a go. I thought that may be a bit "nasty" for the finish, but if you guys say its OK

ta
Chris


Avoneer - 4/2/06 at 11:51 AM

What surface is it on?

Finger nail might be a good start!

Wynns Carb cleaner is also a good one.

Pat...


the_fbi - 4/2/06 at 11:53 AM

quote:
Originally posted by Avoneer
What surface is it on?

Finger nail might be a good start!

Wynns Carb cleaner is also a good one.

Pat...

All around the bonnet edge, to side panels, nose, scuttle.

Basically when the car was delivered there were no catches to hold the bonnet on, so duct tape was used.


mark chandler - 4/2/06 at 12:34 PM

hair dryer and clean clothes, no danger of damaging the finish with solvents etc. Just warm the residue up and it will migrate to the cloth when rubbed.


Spyderman - 4/2/06 at 01:11 PM

WD40 is pretty good at removing adhesive. Certainly worth a try.


Avoneer - 4/2/06 at 01:16 PM

White spirit / wd40 and lots of rags / finger nail to get off the worst.

Then G3 (or T Cut) to polish off the fine glue.

Pat...


Russ-Turner - 4/2/06 at 02:21 PM

If you are worried about possibly damaging your paintwork then baby oil is just as good. Rub plenty over with cotton wool so it soaks in and leave it for a bit. Then go over with hot soapy water and a tough cloth.


David Jenkins - 4/2/06 at 03:54 PM

"Sticky Stuff Remover", obtainable from most hardware shops. Smells like oranges, softens and removes just about any glue residue. Quite cheap.

Even removed dried evostick from my fleece, which I thought was impressive!

David


MkIndy7 - 4/2/06 at 05:17 PM

Flash Dash,

After all the bodywork is only plasic like a dash!, Cheep and Smells nice too!


Confused but excited. - 4/2/06 at 05:42 PM

3M sell an adhesive remover that works really well.
Due to illness, I left masking tape for two weeks on a car that was parked outside.
The paper tape came of in the rain but the adhesive stuck to the paint like a siamese twin, but the 3M stuff got it off a treat.


Fred W B - 5/2/06 at 06:24 PM

Carb or brake cleaner are basically acetone in a can. Just make sue it does not discolour your finish, as acetone affects some plastics - not sure about cured GRP, but acetone is used as a cleaner in GRP work.

What always works for me with sticky residues is to polish it off with Brasso

Cheers

Fred WB


the_fbi - 5/2/06 at 06:54 PM

WD40 did the trick, very impressed actually.

A few scratches I though were scrapes in the bonnet turned out to be something white which came off too. So a nice suprise allround

Thanks for all the tips/advice

Anybody up for a "diff" discussion next http://www.locostbuilders.co.uk/viewthread.php?tid=38612

ta
Chris


Rob Palin - 7/2/06 at 08:07 PM

A bit late with this one: sometimes you can get away without nasty chemicals simply by balling-up a length of masking tape so the sticky side is outwards and sharply dabbing it against the little bits left on the bodywork. If you're persistent it can workquite well.

Same sort of thing works with blu tack on walls & posters. Worth trying first before moving on to the heavy stuff. Just a thought.