Hi all,

I am just in the process of fitting a 2L Zetec silvertop into my Locost. I am having a problem fitting the inlet plenum as the 2 small pipes coming from the bottom of the chamber are hitting a chassis rail. Can anyone tell me what these two pipes are for, can I just cut them off and block the holes or move them so they don't foul the chassis rail. Thanks Nigel






[Edited on 4/11/12 by Dunbikin]

[img]pg]94546[/pg][/img]

[Edited on 4/11/12 by Dunbikin]

Inlet plenum

I've been trying for the last 20 mins to upload that photo. Thanks. The 2 pipes pointing up are the ones I mean, on my plenum they point down.

They use one for the fuel rail regulator and one if needed for a brake servo.

Either cut them short and tap them to m6 and fit a bolt with some sealant or cut them short and plug weld it.

Thanks Wasa, I will get cutting and plugging.

I did have some pic's but cant find them. The plenum above, the ports are pointing down. The inlet is on the other end for fwd setup.

I modify them a little as I hate the nasty bleed screw idea.



[Edited on 4/11/12 by big_wasa]