here's a problem i'm having. a direct copy of the mail i sent to motorsport electronics.;
The car runs perfectly smooth without the vvt controller connected to the wiring.
But when i plug it in ( it's wired up ok and it works) but the engine stalls at certain points in the rpm range ( not always the same rpm/effect ) i wired it up with shielded wire for all sensors, even the power feed and the wiring to the solenoid is shielded wire. Sometimes i see the rpm on my digital dash peak to 10.000 rpm when it is happening ( when it is more around 3/4000 rpm) the digital dash is wired to the dis coil. Megasquirt seems to not have that problem with the rpm's (from flywheel sensor & also shielded wiring) the shield on the wires is connected to ground on both sides.
Any idea's on what may cause my problem?do Keep in mind that the car runs perfectly with the vtt controller not hooked up to the wiring, so even though it's a base map i dont think that could cause the problem.
Hoping you can help me out!
------
so any idea's on here? the people know what i'm experiencing the more chances i have of getting it fixed!
tonight i'll try and do some test runs with the scope hooked up to the coil, but it's raining and windy and my littles test road is covered in mud and horse sh*t so i'd rather not have to do many testruns
greetz!
Frederik
