Board logo

Injector Flow Rates
Project7 - 1/3/06 at 07:52 PM

Hi,

I have a set of Injectors from a Rover 2.0 T Series engine with the flowing numbers

03183GB
MJY10029
2237

Does anybody know the flow rate for this type.

Thanks

Tony

Project7 - 1/3/06 at 08:14 PM

Cheers Mark, but i checked that web site already and couldnt find anything that matched up.

Might just end up guessing the flow rate based on the BHP the T series produced????

britishtrident - 1/3/06 at 08:29 PM

According to the Rover 820 parts list the same injectors were used on Turbo and normally aspirated Rover T16s ---- that means they should be good for bit over 200bhp.

Project7 - 1/3/06 at 08:46 PM

quote:
Originally posted by britishtrident
they should be good for bit over 200bhp.


Cheers - thats surprising - probably means they're be abit OTT for my 1.6 zetec though.....

[Edited on 1/3/06 by Project7]

britishtrident - 1/3/06 at 09:11 PM

quote:
Originally posted by Project7
quote:
Originally posted by britishtrident
they should be good for bit over 200bhp.


Cheers - thats surprising - probably means they're be abit OTT for my 1.6 zetec though.....

[Edited on 1/3/06 by Project7]


It should be OK the standard non-turbo 820 kicked our 138ps a warm 1.6 Zetec shouldn't be that far off. I am pretty sure the Turbos ran a 4 bar fuel presure and the non Turbo 3 bar.

Project7 - 3/3/06 at 10:35 AM

Ok, i'll try them and see how they go -thanks for your help