Hi,

I'm fitting a Vapor dash to my car which is powered by a fireblade engine.

Can I connect the bikes tacho output direct to the Vapor's tacho input?

Can I use "ordinary" wire to extend the speed sensor and temp sender wiring?

Any help gratefully received!

Cheers

Chris

I have a vapor and the tacho is connected
to the coil output,on a car engine and it works fine.the speedo and temp sender need a proper extension cable as the wires are too fine to solder(i have tried and it dont work)the cable is only about fiver.Its not worth buggering about with wires when the correct parts are so cheap.Nice bit of kit though and works great.

Andy

[Edited on 29/3/09 by lotusmadandy]

I used ordinary wire to extend these and it works fine.

Scooby

Thanks!

Just to ressurect this, I never did find out if I could attach the tach output direct to the vapor rpm sensor,

anyone know?

Cheers

Chris

Anyone in the same boat - don't bother asking Trail tech - they don't know!!!!

Cheers

Chris

[Edited on 15/4/09 by chrisg]