LocostBuilders - powered by XMB

megajolt coil wiring.

Danozeman - 9/7/06 at 09:06 AM

I have megajolt running my zetec and a vicky green loom. Theres 2 white wires for the ign system. I have the whole lot wired from one of the wires for the ign feed as shown on the wiring diagram. Is this ok for the coil though?? it runs well so theres not a problem just wondred if this thin wire was ok for the coil, mj and edis together.

paulf - 9/7/06 at 07:34 PM

i dont know how thin the wire is ,but the current draw of the edis and megajolt is only a few milliamps, the only real load is the coil when energised, I assume that if it is designed for a standard ignition system it will be fine with the megajolt.
Paul.

quote:
Originally posted by Danozeman
I have megajolt running my zetec and a vicky green loom. Theres 2 white wires for the ign system. I have the whole lot wired from one of the wires for the ign feed as shown on the wiring diagram. Is this ok for the coil though?? it runs well so theres not a problem just wondred if this thin wire was ok for the coil, mj and edis together.

Danozeman - 10/7/06 at 04:13 PM

cheers Paul. i will leave it as it is for now then.