hi all, i have the koso rx1n clcoks, i have wired it up. but have not done the revcounter yet, has anyone used the edis or megajolt output? also will it work if i connect it upto the ford type coilpack? as in the wiring diagram for the koso clocks it sugests that it needs to be a positive feed. is this right?
any help would be appreciated.
thanks

rob

hi try wrapping the wire round number 1 spark lead from memory try that first

hi try wrapping the wire round number 1 spark lead from memory try that first

ye was gonna use that as last resort as i would like it connected properly to the megajolt or edis or coil.

if it needs a +ve signal you could show it a +ve signal via a resistor and then the _ve to the coild pack would override this so you would in affect have a switched +ve signal.