hi folks anyone out there know if replacement terminals are available for the edis unit
cheers in advance
bottom of the page
http://trigger-wheels.com/store/index1.html
I've not bought anything form them yet, but I need a trigger wheel for my car and was thinking about getting it from them - anyone here used them
?
Ordered a trigger wheel and set of EDIS stuff from them last week - very quick delivery, and the EDIS stuff has (apparently) all been tested by them,
and came with a cable tail on all the components as well.. The trigger wheel was good too.
HTH
Vince
Yup running one on the V8, Top bloke and excelent delivery. recomended
Good qulity I have logged manny a RPM and no trigger errors reported so far.
Regards
Agriv8
quote:
Originally posted by mcerd1
bottom of the page
http://trigger-wheels.com/store/index1.html
I've not bought anything form them yet, but I need a trigger wheel for my car and was thinking about getting it from them - anyone here used them ?
quote:
Originally posted by 24vseven
as regards the connector i have the plug supplied by them but was thinking of fitting new termerminals into the plug itself
quote:
Originally posted by Scoobylav
We have a trigger wheel bought from them that we dont require if you are interested ?
That might be a bit too big for what I had planned - but I need to mesure again it before I know for sure
I'll need the either the 4.5" or 5.75" one
no just wanted to put new terminals on rather than solder to the wires just trying for a neater job
quote:
Originally posted by 24vseven
no just wanted to put new terminals on rather than solder to the wires just trying for a neater job
If you solder and heatshrink far enough up the wire it will be inside your loom covering and nobody will see it anyway. Don't get bogged down with little details and make the job harder than it needs to be.
quote:
Originally posted by Peteff
If you solder and heatshrink far enough up the wire it will be inside your loom covering and nobody will see it anyway. Don't get bogged down with little details and make the job harder than it needs to be.