Board logo

ignition ht wires
Bitten hero - 21/6/08 at 04:45 PM

hi all , prob already been answered but i can not find it.
where can i get some ht wires to extend my zzr1100 coil to plug wires. got some car ones but they are too thick and i can not get them into the plug connectors .need four at about 22" long so i can move my coils.
cheers gary


Guinness - 21/6/08 at 05:21 PM

I wouldn't do that if I were you.

I got a set of thin ht leads and located my coils over the gearbox. They broke down quite quickly and led to loads of rough running.

Relocated the coils, fitted an original set of Kawa leads and it's better than it's ever been.

The Kawa leads are stranded copper wire, and silicone / carbon leads just didn't seem to work as well.

HTH

Mike


tks - 21/6/08 at 05:25 PM

again a no no...

the leads are measured and every piston is tweaked for his leads..

a bike engine is a high revving engine...

running at 10.000rpm minute =
166revolutions per second!!

Thats almost 5miliseconds per revolution!!
Trust me you cant have a bit more delay...

Tks


Bitten hero - 21/6/08 at 05:30 PM

oh bugger thats not good as the coils will not even go round the air box they are that short. might have to look into this more