Hi all

Just thought i would share this with you all

I have just started working at engineering and fabrication company.
We specialise in making large tanks and chassis for the drain industry.
However we have all the equipment for
Cutting folding and welding any type of material,Alli,Galv.Stainless etc

We have a very good Ali welder in house and is under used at the moment!!!!

Just thought i would let you know,i may be able to get things done a bit cheaper than other companies.

Cheers
Mick

[Edited on 13/10/05 by sonic]

Hi Mick [Sonic] how about bike carb manifolds to car engines?
Graham

Eyup Graham how you diddling!!!!!!!

i thought the same thing and i carnt see a problem.
I was thinking if you got a standard inlet manifold and cut the flange off and milled it flat and then its a simple job of welding tubes on to suit.
Just need to know pitch of the tubes

waiting to get mine back and then we could copy it for anybody who has a 1.6 Xe corsa boys etc

Cheers
Mick

Hi guys,

Sounds very interesting Mick

How about a pinto manifold too!

Hows your car coming along? and will you be coming to elvington on 22nd?

Cheers

Mark

Shame it's not precision engineering - we could have had a mutually beneficial business proposition going...

HI Mark [ Mookaloid ] how you doing im hoping to go to elvington so hope to see you there weather permitting . Graham

Hi mark
how you doing
yes weather permitting i will be going to Elvington on the 22nd
We can have a chat there

cheers
Mick