Afternoon fellas. Just looking at completing my dash, however it states in the SVA that the lower edge has to be radius 19mm (5mm if not rigid
material). Does this mean the horizontal lower edge or does this include the vertical drop down to the central tunnel and chassis on the outside?
Any comments would be appreciated.
Cheers
Just the horizontal edge. The other bits just have to meet the normal radius requirements. Don't forget its 19mm radius not diameter!
adrian
Cheers. That makes life a lot easier!
Agree, just the horizontal. Also, my tester was clear that it was just the bottom. I had trimmed the edge with a small edge trim (!) then fastened
some 50mm plastic water pipe along the lower edge behind the dash panel - almost out of sight. I was concerned that the edge formed by the bottom of
the dash and the trim would fail as it was not 19mm radius at that point, but Mr SVA was clear that it was just the bottom edge and as such my water
pipe did the job. Also does a good job of stiffening the dash panel
Simon
Cheers Simon.
Just had a look at your motor and I can see your dash which helps a great deal.