I am not even sure if any exist, but does anyone know if any other exhaust manifolds match up with the sierra 1.8 CVH engine?

Just looking at options as well as the original cast one with the engine.

Cheers

Adrian

[Edited on 20-1-09 by AdrianH]

Hi Adrian,


I too would be interested in a source of one of these as I am using the 1.8cvh ( see my piccies) I did see one for £200.00 in stainless I'll look for the link. Send me a u2u if you find one. Kev

Hi Kev;

I believe it may be possible to use the existing manifold and part of the twin down pipe section, but could mean a sharp bend to come out at the bottom of the side panel to have another bend to run down the car.

I am hoping some one may say yes a Zetec or a xxxxx fits the same, I just do not know enough on engines.

Adrian

[Edited on 20-1-09 by AdrianH]

There was a thread on here yesterday about Zetec Exhausts from EBAY / Robin HOOD. Think the KIT was £170 quid.

Both Ford Zetec and and Rover T series manifolds can be adpated.

However I have a puka Westfield CVH manifold at the back of the shed that might be 4 sale

The only one that fiits without modification is from a 1.6 CVH. I put one one my Indy when I had the 1.8 cvh in.

The port spacing on the CVH is exactly the same as a Zetec, so with a bit of messing it should be possible to modify a Zetec exhaust to fit.

I now have the CVH exhaust on my 2.0 Zetec. All I did was to cut the manifold plate off a Focus non-cast manifold and weld the CVH maifold to it.

Stu

Thanks all for the information will store away for later use.

Adrian