hi...

just starting to make my own 4 branch manifold....

im doing it from 316 stainless and im going to tig weld it...

im cutting my manifold plate tommorow but i would like to know if anyone has made there own, and if there is anything to watch for?

cheers

barry

not made one but from remembering what others have said about making theirs, the plate has a tendency to warp wehn welded so make it thick and bolt it down.

was going to use 8mm thick....

here you go.


exhaust finished 1

Exhaust started

possible exhaust blow ?

exhaust from side

exhaust from front

exhaust heat sheild 2

Have a look at tuned lengths for the Pinto, there is a little free BHP to be had if you have the lengths and diameters of the primary's correct.