Im In need of help!
to finish my wiring loom i need the boots that push on to the coil pack,oil sensor and water temp sensor!

the little black connectors and boots, its for a pinto engine.

Any ideas where to get these from?

Cheers

Aaron

Scrappers for those I reckon, or heat shrink tubing could be used I suppose.

Cheers

Rich

yep i was thinking the same ..........thank you

I've got the same ones on my pinto and I reckon these would be a close fit, and far easier than finding a sierra with that particular management in the yard:

LINK

HTH
Stott

EDIT: I read that you wanted Dizzy, and water temp sensor (in manifold one), I am a nob, Sorry.

Although, as stated I have the same lump, I used the coil ones that were on my loom, you could use nuts and crimp on loops though with generic boots you can buy at any show etc. For the oil and water senders I used 2 different sizes of female crimp on bullet connectors, with a little black heat shrink over them for asthetics, it wasn't needed for insulation as they were the red/blue/yellow type crimps so were pre insulated.

[Edited on 26/9/10 by Stott]

www.polevolt.co.uk

Or

www.efi-parts.co.uk

Both have the boots in rubber and plastic.