I have been doing some work on a megajolt for a friend and we have got it up and running nicely!

We have loaded a TPS map, and run the calibration routine writing it back to the MJLJ V4. The Load guage now shows 0% with throttle closed and 100% at WOT.

However, now that I look at the map I notice it shows load bins from 0 to 152 when I thought that the bins should go between 0 and 100%.

Does anyone know what the propper limit should be on the load scale? Should I change the 0-152 to 0-100?

think 0 - 100 to be right

Sound right. It seems to agree with Brent on the auto labs site.

I'll factor the values down to range up to 100% then and reload the map.

Cheers!

Here is my zetec mj map that I use. not that refined but seems to work well enough.

My MJ Map

Here is the actual map that I use Download map

Cheers

Rich

[Edited on 31/12/11 by RichardK]

Cheers Rich, that looks like what I was expecting to see.

Definitely looks like a reload then.

BTW, finally got started on my megajolt project and fitted your old trigger wheel and VR sensor the other day.

Ian