Board logo

Propshaft UJ bearings (Sierra/BEC)
ReMan - 30/3/12 at 12:53 PM

How many needle rollers in each joint?

Davg - 30/3/12 at 03:29 PM

Ah Ha guess you dropped them when you took apart

off top of the head cant tell you the number, best place the remaining ones you got in the cap with a bit of grease & see if you have space. Then grovel about the floor where you split the joint

cheers D

adithorp - 30/3/12 at 03:45 PM

quote:
Originally posted by ReMan
How many needle rollers in each joint?


a. A lot
b. More than you've found

ReMan - 30/3/12 at 07:46 PM


Was it that obvious
I've retrieved plenty, but I cant decide whether ther should be a 1 proller space or not?

Chippy - 30/3/12 at 10:02 PM

If you have enough to fill it leaving just one space then you have the lot, more space than that then get on your hands and knees. Cheers Ray

rusty nuts - 31/3/12 at 06:57 AM

If you haven't found them all try using a magnet in the area that you dropped them, an old speaker magnet comes in handy

ReMan - 31/3/12 at 07:13 AM

So you can laugh a bit more....
I split another joint to have a count and borrow a needle to make up and did the same thing again