Hi

Does anybody have any pics of their engine mounts on a zetec going into a locost they could post? Need a hand with locating one. Mine is a silvertop.

Cheers,

mine







Muzchaps


Borrowed engine mount pic

Loads more if you do a search. One tip I would offer is, make the plate from 5~6mm steel

here is the page on my blog where I have step-by-step instructions on how I did mine.

They're for a duratec but the entire principle applies just as much.

M

Mine::









Materials from ebay for about £15 IIRC. From these guys http://www.locostbuilders.co.uk/viewthread.php?tid=166386 - very good service.

[Edited on 4-11-12 by loggyboy]

Here you go.


zetec height


1st one in

ATB Dan.

Volvo 122 motor mounts for me 3" diameter threaded bolt out top and bottom, strong.