Board logo

Crossflow Torque settings
Nickctp - 7/4/13 at 06:53 PM

Evening all,

Does anyone know the correct torque settings for the following on a 1600 X Flow?

Main Bearing Caps

Big end Bearing caps

Head bolts

If you are not sure, does anyone know where I can find the correct settings?

Cheers

N

DavidM - 7/4/13 at 08:19 PM

quote:
Originally posted by Nickctp
Evening all,

Does anyone know the correct torque settings for the following on a 1600 X Flow?

Main Bearing Caps 55-60 lbf.ft (75-82 NM)

Big end Bearing caps 31-35 lbf.ft (42-48 NM)

Head bolts 5, 21-31, 52-56, 66-71 lbf.ft (7, 28-42, 70-76, 90-97 NM) Tightened in stages with the last after 10 to 20 minutes.

Recheck after engine has been warmed up for 15 minutes at 1000 RPM

If you are not sure, does anyone know where I can find the correct settings?

Cheers

N


These are from the Wallage crossflow book.

HTH

David

[Edited on 7/4/13 by DavidM]

[Edited on 8/4/13 by DavidM]