Hi all

I'm new to the site, so good to meet you all

I have a 2 litre blacktop with GSXR TB's.

The injector holes were blocked off by the previous owner and one has come off, drew in a stack of air, and burnt me cat out!

I could do with a bit of advice on the best way to block them off?

Thanks

Cortez

Tap the holes out then screw something in with plenty of fuel proof thread sealant, cut down cap head screws should do the job and look smart.

Get some blanks made up in Ali, I have two or three left if your interested for beer tokens...

I cut some little alloy discs and epoxied them in. They'll never come out now

[Edited on 5/6/13 by Ben_Copeland]

Thanks all and sorry for slow reply!

I've cut 4 blanks from 3mm aluminium and will bond in place.

Thanks again