Does anyone know whether you can use the electronic output on a type 9 gearbox in connection with the Tiger electronic speedo (ETB Gauge)?

There are three wires out of the type 9 electronic spedo sender, but only two to the speedo.

The speedo uses a read switch to pick up on pulses but the bit in the gearbox is a cog, although it must have something inside it which might be magnets and a sensor?

Any ideas?

Mark.

give etb a call - they are bound to know

Not sure about the colours but the three wires on the sensor will be +ve, earth & signal. The two wires on the speedo will be signal & earth............ probably.

quote:

---

Originally posted by RazMan
Not sure about the colours but the three wires on the sensor will be +ve, earth & signal. The two wires on the speedo will be signal & earth............ probably.

---

I'm using one with my VDO speedo. Works fine.

Quick hijack

Anybody used these with a telemetrix speedo, might be worth while giving this a try rather than messing around with the magnets (AGAIN)

Cheers


David