Chaps,

Made one, one to go





Hope you like!!!

ATB

Simon

Looking good there, whats it for? I fancy a turbo on my zetec engine. You up for making me a manifold??

Looks very nice, well thought out, angles look good for flowing abilities.

Looking good Simon, nice and compact.

Where did you source the flanges from ?

rgds Mark

Coozer,

Probably gonna be a bit short of time for anything for a while - decorating/work/kids/wife and the evolution of Deimos (twin turbos/FI for my R V8), but thanks for the faith

marcjagman,

Yeah, it's also the only way I can get it to fit

Mark,

Got the flanges from Custom Chrome (iirc about £80), and Sch40 from All Stainless Ltd. Should've taken one to "someone I know" who can cut them out

Got about 20mm clearance to chassis rails

CaLviNx,

All stainless steel (Schedule 40 butt weld pipe), TIG'd. Purging? Outside done with an angle grinder, powerfile, router and DA sander! Took about 5 hours.

ATB

Simon

[Edited on 13/10/06 by Simon]

those manifolds can be made in mild steeland migged if its thick enough wall section .

i have a friend on night shift at a laser cutters1!!!

still looks nice

simon can i buy back my manifolds then? i need one for the n/s bank for my single turbo

[Edited on 14/10/06 by froggy]

Like the look of the manifold. I've been doing Pinto turbo manifolds. Started with mildsteel ones, these can crack unless suported well. Then changed to stainless.
I used sch 10 pipe though 40 was a bit thick and 10 was easier for me to weld.
This is my stainless one.