Can someone tell me where the Idle speed screw is on these carbs. Picture would be nice.

[Edited on 22/3/07 by grusks2]

Its the one in the bottom right of the picture in the link; It adjusts the idle for all 4 carbs.
Steve,

http://www.cartestsoftware.com/fz1/images/mikegtx45.jpg

[Edited on 22/3/07 by stevec]

Sorry steve my mistake, its the mixture screw that im after. Its running rich down low 1000 - 3000 rpm ( wet black plugs and spitting back through the carbs)

It ticks over fine but soon as i try to bring the throttle up it pops and farts so to speak then tries to cut out.


I've been told that the low end of mixture is adjusted by a screw on each carb and above 3000 is by adjusting the needle clips.

Does that sound right at all.

[Edited on 22/3/07 by grusks2]

[Edited on 22/3/07 by grusks2]

I think these are they,
Steve,

Yup that looks like them. Wind them fully in (stop just after you feel harder resistance) then wind each out exactly the same amount - 2.5 to 3 turns.

Ill give them a go the weekend, they look slightly different carbs, i think Kawasaki and Yamaha have mikuni but slightly different. Finger crossed.

Cheers chaps