how do you make your own adapter plate for transmissions

Weld the two bell housing together with care f they are ali

Here's mine, Rover V8 onto Audi box

Its then sorting out the clutch.
Rescued attachment mated_RH_Rear_small.JPG

Here is my effort, Getrag front gear casing to Type 9. Ignore the flowers
Steve.

Picture linky

Mark if you put that in the 7 where will you sit?

what about the spigot bearing and the shaft wouldent the shaft not sit in the spigot bearing if i added an inch on to the bel housing some thing like that

In front of it !

You need to have a measure up, this method used to be used to fit fiat twin cams into escorts years ago.

I am using the audi flywheel bolted to a rangerover flex plate

[Edited on 28/11/07 by mark chandler]
Rescued attachment Chassis_engine_Sept_2007_small.JPG