I'd need to measure to be 100% sure but think have 10 mm or 1/2 " on the crossflow and v8 which are same dia. as original fittings.
is an 8mm hose adequate for the crankcase breather hose?
1" would be near the minimum size. Crank case prssure costs you power and worse case pushes out seals.
Regards Mark
1" would be near the minimum size. Crank case prssure costs you power and worse case pushes out seals.
Regards Mark
1"
I'd need to measure to be 100% sure but think have 10 mm or 1/2 " on the crossflow and v8 which are same dia. as original fittings.
The gizmo I bought from Burtons and fitted to my x-flow block has a 1/2" outlet. If I could be bothered to fit an oil filler cap with a breather
outlet then that would be 1/2" too.
The original pipe that went from the now-removed PCV to the inlet manifold was smaller, IIRC.
[Edited on 2/3/08 by David Jenkins]
quote:
Originally posted by David Jenkins
The original pipe that went from the now-removed PCV to the inlet manifold was smaller, IIRC.
[Edited on 2/3/08 by David Jenkins]