jamrogers
|
| posted on 20/12/07 at 09:36 PM |
|
|
hand brake cable
i'm fitting the hand brake cable and have cut off the rubber bit, the black plastic cone and the white plastic end, but am confused about how to
attach the cable to the rear backplate should the nut secure it? if so how its on the wrong side of the backplate?
 
Rescued attachment DSCF0034.JPG
build diary http://jamstigeravon.blogspot.com/
YouTube
https://youtu.be/JwwwilUd5Zo
|
|
|
|
|
Mr Whippy
|
| posted on 20/12/07 at 09:48 PM |
|
|
looking at the pic, the clue is that nut and how the white plastic bit fits into the handy recesses on the back plate,
the nut would be on the wrong side cos you haven't taken it of the cable yet...
then again did you through away the - rubber bit, the black plastic cone and the white plastic end? 
[Edited on 20/12/07 by Mr Whippy]
Fame is when your old car is plastered all over the internet
|
|
|
jamrogers
|
| posted on 20/12/07 at 11:05 PM |
|
|
you can't get the nut off as it doesn't go past the ball on the end of the cable..... any other ideas?
build diary http://jamstigeravon.blogspot.com/
YouTube
https://youtu.be/JwwwilUd5Zo
|
|
|
Avoneer
|
| posted on 20/12/07 at 11:24 PM |
|
|
It just sits in the hole in the picture and the tension when you connect the cable to the pads holds it all in place.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
Aboardman
|
| posted on 21/12/07 at 12:06 AM |
|
|
And if you can still get access to the nut after installed it will allow some adjustment assuming you do not fit the cable with the nut screwed all
the way down the threaded section.
|
|
|
%20(WinCE).JPG)
