Thinking about it
|
posted on 10/10/10 at 09:48 PM |
|
|
Any tips on curing creaky floorboards?
I have the carpet up in the bedroom awaiting the fitting of a new one later in the week.
I have a few creaky floorboards which I think have dried out due to central heating pipes beneath. Any nails have been hammered and screws tightened.
But still creaking.
Any tips to help short of replacing them?
|
|
|
corrado vr6
|
posted on 10/10/10 at 09:54 PM |
|
|
Little bit of glue on the offending boards and make sure theres no tight joints that are still moving and rubbing together, perhaps if theres any
boards that are only nailed and still creak after being pin punched tighter replace with screws
http://r1indy7.wordpress.com/
|
|
Richard Quinn
|
posted on 10/10/10 at 09:58 PM |
|
|
Never tried it but I'm sure that I read somewhere about brushing talcum powder into all the joints.
|
|
Thinking about it
|
posted on 10/10/10 at 10:01 PM |
|
|
quote: Originally posted by Richard Quinn
Never tried it but I'm sure that I read somewhere about brushing talcum powder into all the joints.
Should be ok then. My wife will be throwing the talc about on the floorboards this week with no carpet so we will see.
|
|
slingshot2000
|
posted on 10/10/10 at 10:23 PM |
|
|
Lift any boards that you can see or feel have all-ready been up. Use a nice soft brush to clean off any dust from the tops of the joists that boards
are sat on, remove all old saw dust and any other debris that lazy plumbers may have left behind. When re-fastening down, make sure you dont
nail/screw through any cables in joists. (You dont have to worry about nailing pipes, plumbers will have made them an easy target for you!)!
|
|
Jomibo
|
posted on 11/10/10 at 07:38 AM |
|
|
quote: Originally posted by Richard Quinn
Never tried it but I'm sure that I read somewhere about brushing talcum powder into all the joints.
Ive heard of using talc before, never tried it though
|
|
steve m
|
posted on 11/10/10 at 08:04 AM |
|
|
Talc does work, but not for long !!
I had the same problem with our stairs,
so when the carpet was off , i glued, screwed everything together, and was all tight as drum
Carpet went down , and was fine for a few years, but they do creak now
|
|
adithorp
|
posted on 11/10/10 at 09:52 AM |
|
|
Go on a diet.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
Steve Hignett
|
posted on 11/10/10 at 09:54 AM |
|
|
WD40?
|
|
adithorp
|
posted on 11/10/10 at 11:18 AM |
|
|
quote: Originally posted by Steve Hignett
WD40?
I was going to say something about the smell of lube in the bedroom... but you'd probably jump to conclusions!
adrian
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
Ninehigh
|
posted on 11/10/10 at 07:33 PM |
|
|
Talc works, although our entire upstairs creaks so it either doesn't work for long or it was somewhere else I tried it. Thinking about it, it
might have been parent's bathroom...
|
|
David Jenkins
|
posted on 11/10/10 at 08:24 PM |
|
|
Just call it a security device...
Nightingale floor
|
|