ChrisRidge
|
| posted on 3/7/12 at 02:53 PM |
|
|
Changing crown & pinion gear in diff
Can this be done in a pretty well equipped workshop or is it a specialist job? Does the end float & run out have to be set up?
Any advice welcomed!
Chris
|
|
|
|
|
daviep
|
| posted on 3/7/12 at 03:00 PM |
|
|
Entirely possible but you will need to setup depth of mesh, pinion preload, crownwheel preload and backlash.
Cheers
Davie
“A truly great library contains something in it to offend everyone.”
|
|
|
ChrisRidge
|
| posted on 3/7/12 at 03:29 PM |
|
|
Thanks for that.
Might be better to buy a diff with the correct ratio already then.
|
|
|
jossey
|
| posted on 3/7/12 at 07:35 PM |
|
|
But isn't it cheaper to change a 3.92 to something better than try buy a 3.14 etc????
Thanks
David Johnson
Building my tiger avon slowly but surely.
|
|
|
