Hi folks,

I have a problem connecting the sender with the speedo. I have this sender

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=260802779601&clk_rvr_id=494361429041

and i have this speedo

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=250761383431&clk_rvr_id=494356961511

The current setup of the sender is as follows:







I made the speedo connection as in the manual, and it is working, but it seems that i do not get any signal from the sender. I am doing the wires as in the instructions for the sender, but i do not get any signal. I made a small mistake and connect the speedo signal cable to the tacho wire and it works. So where is the mistake with the sender installation - 2 wires, brown - ground, blue - signal. the magnet is very strong, tried with another one to decrease the gap - same sh-t.
Help please.
Thanks.
Yavor

Hi, so many answers, i do not know which one to use)))) No worries folks, problems solved - just used the original electronic VSS of the MT75 gearbox ( 3 wires- power, ground, signal) and calibrate the speedo (1 mile - 8500ish pulses).
Cheers
Yavor