Shogun969
|
posted on 2/12/06 at 09:35 PM |
|
|
ZX9 R
Hi,
Can anyone with Knowledge of the ZX9 B engine confirm the size of the resistor required to be fitted in the ECU Ign feed Please ?
I have installed a 100 ohm resistor, i have a spark and petrol but it back fires every now and again when being turned over and wont actually fire up
and run .
Any suggestions ?
Thanks
|
|
|
Wadders
|
posted on 2/12/06 at 09:58 PM |
|
|
100ohms is correct, are you sure the plug leads are on the right plugs?
Originally posted by Shogun969
Hi,
Can anyone with Knowledge of the ZX9 B engine confirm the size of the resistor required to be fitted in the ECU Ign feed Please ?
I have installed a 100 ohm resistor, i have a spark and petrol but it back fires every now and again when being turned over and wont actually fire up
and run .
Any suggestions ?
Thanks
|
|
Shogun969
|
posted on 2/12/06 at 10:03 PM |
|
|
Hi,
I believe plug leads are right 1 coil to plugs 1 & 4 , the other to 2 & 3, i have checked this against the wiring diagram but will recheck it
tommorow.
Thanks
|
|
JoelP
|
posted on 2/12/06 at 10:44 PM |
|
|
on my C engine, the leads were paired 1+2 and 3+4, but thats not saying much since i cant count and dont have the engine anymore anyway.
|
|
mac1
|
posted on 2/12/06 at 11:50 PM |
|
|
Hi Nick, you have U2U
Mark
|
|